How Do I Make A Roof Rake

Position a bracket on each side of the.

How do i make a roof rake.

Here s what i came up with. Make this easy avalanche roof rake for the winter and let a clever diy design do all the work for you. Begin by cutting two 12 sections from one on the 1 x 10 pvc pipes. Use your clamp to attach the two 4 inch brackets to one end of the aluminum pole positioning one angled bracket on each side.

When the snow started to pile up on handyman bill. On the 1 x 12 arms where you placed the marks in the previous step use the hole saw to bore straight through. Measure and place a mark 2 from an end. The roof rake plates are installed in different widths depending on the surface being covered.

Make sure the holes on the brackets are lined up and are angled at 90 degrees. Attach the two 4 inch angle brackets to the end of your aluminum pole. Drill straight through the aluminum handle through one bracket hole to the hole on the other side using your. Use larger rake plates such as 1 by 4 inches and 1 by 6 inches when there is an infinity ledge at the end of the gable.

An added bonus was that i could use one end of. Without a real roof rake i was forced into searching the garage to craft something homemade. I used the driveway sealer squeegee and an extension pole to work as a snow roof rake. Insert your 2 1 2 inch.

Use the drill to make a hole in the aluminum pole using the bracket holes as a guide. I have to say it worked great i used the metal part face down not the rubber part.