How Does A Standing Seam Metal Roof Work

Continuous panels run from the ridge of the roof down to the eaves.

How does a standing seam metal roof work.

It s also described as having raised seams or vertical legs that rise above the level of the panel s flat area. Standing seam consists of sheet metal roofing panels joined side by side and attached to the roofing deck with concealed fasteners. The main idea to remember for standing seam systems is that the fastener is hidden whether the panel is attached to the roof deck using a clip or is directly fastened to the decking material under the vertical leg using a fastener flange. Standing seam systems can be used for either metal roofing which is the most common or metal walls.

When installing a standing seam it is strongly recommended that all asphalt shingles are removed before the installation in order to prevent avoid the telegraphing effect where horizontally installed shingles punch through the vertical sheet metal roofing panels causing unsightly dents that cannot be fixed removed. Standing seam metal roofing is defined as a concealed fastener metal panel system that features vertical legs and a broad flat area between the two legs. A standing seam metal roof system is a series of panels that are locked together at the seams or seamed mechanically. A standing seam metal roof takes a different installation approach than the traditional metal roofing method.

The ribs standing seams are usually between 12 and 24 inches apart depending on the length of the panel and aesthetics of the structure. This will sooner or later cause the protective coating to wear off thus inviting the rust spots to start popping up all over the roof. Standing seam metal roofing is a particular type of metal roofing that raises the seams above the level of the roofing itself. To provide excellent insulation and prevent leaks contractors use caulk to seal the nailed seams.

They lock the seams of each roofing panel ridge in place with nails. The connecting point where the two separate metal panels meet forms a vertically pointed rib or a seam that is one inch to inch and a half high.