How For Put Nail On The Felt In Roll Roofing

All nails and staples should be placed on the lower half of the paper.

How for put nail on the felt in roll roofing.

The paper should then be nailed in or stapled every three to four inches across. Use 1 inch nails for new roofing. When unrolling the next adjacent roll allow for at least a two inch overlap. They are long enough to penetrate the sheathing.

Tack it in place at the corner with the end flush with the end of the roof and the bottom edge of the roll right along the bottom of the roof. Secure the outside edges with plastic capped roofing nails at 12 inch intervals. Step 3 nail down the 18 inch roll roofing sheet that it is covering the valley. Start the roof felt at one bottom corner of the roof.

In roofing one square equals 100 square feet. Use a trowel to spread roofing cement over half or more of the strips. Apply rolled roofing rolled roofing has become more and more popular in recent years. You will need 1 10 gallon of lap not mastic cement for every roll and 2 pounds of roofing nails for every square.

Place this roofing material so it straddles the valley. Step 6 overlap next roll. Where a roll ends and a new one is begun the two rolls should be overlapped by four inches. Nail the two rolls in the overlap at 12 inch intervals.

Nail the roofing in place with short roofing nails spaced 6 inches apart and 1 inch in from the outer edges of the roll roofing. The overhang to the next strip should be 3 8 inch. Step 5 secure ends. Repeat this until the entire roof is.

An underlayment of felt roofing is optional. When compared to shingles rolled roofing is far cheaper and much easie. If you have a sloped roof cut strips of roofing 9 inches wide position them flush with the drip edges along the eave and rake and attach them by driving two rows of nails that are about 3 inches apart.