How Do I Remove A Piece Of Vinyl Siding

The vinyl siding zip tool will save you loads of time.

How do i remove a piece of vinyl siding.

Locate the vinyl siding piece above the piece you need to replace. Hold the loose undamaged piece of vinyl up and out of the way with one hand. How to remove small pieces of vinyl siding. Use a cat s paw or other small pry bar to pull the nails from the course you need to remove.

First you nail up the new piece driving nails through the slots in the nail hem then you connect the buttlocks with the zip tool. Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. Installing a replacement piece of vinyl siding is the reverse of removing the damaged panel. How to remove and replace a section of vinyl siding.

Once the zip tool is latched onto the lip pull the siding piece downward and slide the tool horizontally across the entire length of the panel unhooking the lip. Start by lifting an overlapped piece of vinyl on the top row. You should be able to slide it horizontally and remove it from the channel to expose the nails from the second row down. Use a zip tool to disconnect two pieces of siding.

Look for a horizontal seam between two courses of vinyl siding. With the other use the claw end of a hammer to pry up the nails holding the damaged piece of vinyl to the wall. To remove a piece at your eye level slide the zip tool under the piece above that one. Use the zip tool to release the buttlock at the top and bottom of the piece you want to remove.

Working in one direction unzip. Repeat until you re at the ground and then remove the surrounding trim. Reveal the nails anchoring a piece to the wall by sticking the zip tool under the bottom of the piece above it. Remove the nails one at a time to disconnect the entire length of vinyl.

Insert the tip of the zip tool into the. Look under the siding piece you just located for a short flat notch. Go to the end of that row either near a corner piece or a j channel.